This raw frame features a distinctive 1-5/8" diameter single loop front downtube and 1-1/4" diameter lower rear frame rails. The rake is set up to use stock length replica Spring Forks with a 7/8" stem.
Engine mounts are cast steel for strength and aesthetics! Single loop frame is constructed to give the look and feel of an early board track racer. *NOTE: Pre-build entire project before painting. *NOTE: All frames are shipped to the lower 48 states by common carrier truck, please allow extra time for delivery. All other shipments will be made air freight collect. Rear axle plates have provisions for the sissy bar, fender brackets and loops for the rear stand. *NOTE: Must order neck cups, axle,front motor mount plates and axle adjusters as required. Distinctive 1-5/8" diameter single loop front that extends under the motor to the rear mount plate. Rear axle plates and rear motor mount fittings are cast steel for an authentic look. Axle plates have 7/8" slots. *NOTE: The rear hardtail section features a 1-1/4" O.D. tubing and the main single tube features a 1-5/8" O.D. tubing.