Grab rail kit includes a mount bracket and 8-1/2" sissy bar top in a black finish. Includes 4 buttonhead screws, 4 nyloc nuts and 4 washers. The 2 black screws are used to hold the side plate to the hand rail.
Tools suggested: set of hex wrenches, combination wrenches, socket set and ratchet, drill bits, drill and masking tape. This procedure may require making permanent modifications to the fender; This may void your warranty. Consult your dealer for more information. This product is recommended for use on steel fenders only. Accepts aftermarket or OEM sissy bar uprights that are NO MORE THAN 10" tall, 6-11/16" wide. Remove the seat from the motorcycle and clean the fender. Place the mount on the fender and determine a mounting location; You may ch oose to slightly bend the backbone to conform to the contour of the fender for a better fit. Measured from top of fender. *NOTE: Generally the rear mounting hole in the moutning plate will be placed so that it will be secured with the rear seat mounting bolt, though it may be positioned in any location by drilling two holes.