S&S CYCLE Cam - 475G - M8

Manfactuer Part #: 310-1002A

Manufactuer Non-Punctuated Part #: 3101002A

Drag Specialties Part #: 0925-1300

Drag Specialties Non-Punctuated Part #: 9251300

Features

• Camshaft gear drive kits increase valve timing accuracy by eliminating timing chain lash and loosely-fit stock chain drive
• Reverses the rear cam's direction of rotation, providing additional operating clearance between cam lobes; as a result, higher cam lifts are possible with the gear drive kit
• Kits include cams, inner gears, outer drive gears, inner and outer bearings, gasket and instructions
• Material must be removed from the inner surface of the stock gear cover to install S&S gear drive cams
• A hydraulic press and other professional-level tools are required to install these kits
• Cam bearings and gaskets must be replaced when installing new cams
• Kits require high-performance valve springs when installed in 99-04 models.
• Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.
• Due to the inherent characteristics of gear drives, you may experience more valve train noise.
• Original equipment specifications
• Bolt-in cam with stock cam timing
• Does not require tuning
• Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.
• Made in the U.S.A.

Specs

Emissions Notice

WARNING
DISCLAIMER: Not legal for sale or use in california on any pollution controlled motor vehicles. Click here for important emission definitions and regulatory compliance and warranty information.

Catalog

• 21 Drag FatBook / Page 738

UPC CODE: